Removing the microphone
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
Steps
1. Remove the stand.
2. Remove the back cover.
3. Remove the system-board shield.
Procedure
Steps
1. Disconnect the microphone cable from the system board.
2. Note the routing of the microphone cable, and then remove it from the routing guides on the display-assembly base.
3. Remove the two screws (M2x2.5) that secure the microphone boards to the display-assembly base.
4. Lift the microphone boards off the display-assembly base.
21
34 Removing the microphone
To Next Page
Loading...
