Replacing the speakers
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
Steps
1. Using the alignment posts on the display-assembly base, place the speakers on the display-assembly base.
2. Replace the four screws (M3 4+7.1 XZN) that secure the speakers to the display-assembly base.
3. Route the speaker cable through the routing guides on the display-assembly base.
4. Connect the speaker cable to the system board.
Post-requisites
Steps
1. Replace the system-board shield.
2. Replace the back cover.
3. Replace the stand.
32
Replacing the speakers 47
To Next Page
Loading...
