Replacing the microphone
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
Steps
1. Slide the microphone modules into the slots on the display-assembly base.
2. Replace the two screws (M2x2.5) that secure the microphone modules to the display-assembly base.
3. Route the microphone cable through the routing guides on the display-assembly base.
4. Connect the microphone cable to the system board.
Post-requisites
Steps
1. Replace the system-board shield.
2. Replace the back cover.
3. Replace the stand.
22
Replacing the microphone 35
To Next Page
Loading...
