Replacing the media-card reader
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
Steps
1. Place the media-card reader board on the display-assembly base.
2. Using the alignment post, align the screw hole on the media-card reader board with the screw hole on the display-assembly
base.
3. Replace the screw (M3x5) that secures the media-card reader board to the display-assembly base.
4. Place the media-card reader shield on the media-card board and align the screw hole on the media-card reader shield with
the screw hole on the display-assembly base.
5. Replace the screw (M3x5) that secures the media-card reader shield to the display-assembly base.
6. Adhere the media-card reader cable to the display-assembly base.
7. Connect the media-card reader cable to the system board.
Post-requisites
Steps
1. Replace the system-board shield.
2. Replace the back cover.
3. Replace the stand.
18
Replacing the media-card reader 31
To Next Page
Loading...
