Replacing the system-board shield
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
Steps
1. Align the slots on the system-board shield with the ports on the system board and place the system-board shield on the
display-assembly base.
2. Align the screw holes on the system-board shield with the screw holes on the display-assembly base.
3. Replace the five screws (M3x5) that secure the system-board shield to the display-assembly base.
NOTE: Ensure that no cable is pinched by the system-board shield.
Post-requisites
Steps
1. Replace the back cover.
2. Replace the stand.
10
20 Replacing the system-board shield
To Next Page
Loading...
