Use the BIOS Setup program for the following purposes:
● Get information about the hardware installed in your computer, such as the amount of RAM and the size of the hard drive.
● Change the system configuration information.
● Set or change a user-selectable option, such as the user password, type of hard drive installed, and enabling or disabling
base devices.
Entering BIOS setup program
Steps
1. Turn on (or restart) your computer.
2. During POST, when the DELL logo is displayed, watch for the F2 prompt to appear, and then press F2 immediately.
NOTE: The F2 prompt indicates that the keyboard is initialized. This prompt can appear very quickly, so you must watch
for it, and then press F2. If you press F2 before the F2 prompt, this keystroke is lost. If you wait too long and the
operating system logo appears, continue to wait until you see the desktop. Then, turn off your computer and try again.
System Setup Options
NOTE: Depending on your computer and its installed devices, the items listed in this section may or may not appear.
Table 3. System setup options—Main menu
Main
System Time Displays the current time in hh:mm:ss format.
System Date Displays the current date in mm/dd/yyyy format.
BIOS Version Displays the BIOS version number.
Product Name Displays the product name.
Service Tag Allows you to enter the service tag of your computer.
Asset Tag Displays the asset tag of your computer.
CPU Type Displays the CPU type.
CPU Speed Displays the speed of the CPU.
CPU ID Displays the CPU identification code.
Cache L1 Displays the processor L1 cache size.
Cache L2 Displays the processor L2 cache size.
Cache L3 Displays the processor L3 cache size.
First HDD Displays the primary hard disk.
AC Adapter Type Displays the power adapter type.
System Memory Displays the total computer memory installed.
Memory Speed Displays the memory speed.
Table 4. System setup options—Advanced menu
Advanced
Advanced BIOS Features
Intel(R)SpeedStep(TM) Enable or disable the Intel SpeedStep feature.
Default: Enabled.
Integrated NIC Enable or disable the on-board LAN controller.
System setup 67
To Next Page
Loading...
