Dell Inspiron 24 3477 All-in-One - Removing the speakers

Removing the speakers
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
Steps
1. Remove the stand.
2. Remove the back cover.
3. Remove the system-board shield.
Procedure
Steps
1. Disconnect the speaker cable from the system board.
2. Remove the four screws (M3 4+7.1 XZN) that secures the tape to the display-assembly base.
3. Lift the speaker (SPK1) from the display-assembly base.
4. Note the routing of the speaker cable and remove the speaker cable from the routing guides.
5. Lift the speaker (SPK2), along with the speaker cable, off the display-assembly base.
31
46 Removing the speakers