Removing the antenna
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
Steps
1. Remove the stand.
2. Remove the back cover.
3. Remove the system-board shield.
4. Remove the wireless card.
Procedure
Steps
1. Note the routing of the antenna cables, and remove it from the routing guides on the display-assembly base.
2. Remove the two screws (M2x2.5) that secure the antenna modules to the display-assembly base.
3. Peel off the antenna modules from the display-assembly base.
15
28 Removing the antenna
To Next Page
Loading...
