Dell Inspiron 24 3477 All-in-One - Chapter 37: Removing the Rubber Feet; Prerequisites; Procedure

Removing the rubber feet
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
Steps
1. Remove the stand.
2. Remove the back cover.
Procedure
Steps
1. Remove the four screws (M3x5 black) that secure the rubber feet to the display-assembly base.
2. Lift the rubber feet off the display-assembly base.
37
Removing the rubber feet 57