Removing the media-card reader
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
Steps
1. Remove the stand.
2. Remove the back cover.
3. Remove the system-board shield.
Procedure
Steps
1. Open the latch, and disconnect the media-card reader cable from the system board.
2. Peel off the media-card reader cable from the display-assembly base and slide it through the microphone cable and speaker
cable.
3. Remove the screw (M3x5) that secures the media-card reader shield to the display-assembly base.
4. Lift the media-card cover from the display-assembly base.
5. Remove the screw (M3x5) that secures the media-card reader board to the display-assembly base.
6. Lift the media-card reader board from the display-assembly base.
17
30 Removing the media-card reader
To Next Page
Loading...
