Dell Latitude 5495 - Heat Sink Assembly; Removing the Heat Sink Assembly

Heat sink assembly
Removing the heat sink assembly
NOTE: This procedure is only for the UMA model. In the discrete model, heat sink is secured to the system board with four
screws.
1 Follow the procedure in Before working inside your computer.
2 Remove the :
a base cover
b battery
c hard drive
d SSD card
e SSD frame
f WLAN card
g WWAN card (optional)
h chassis frame
3 To remove the heat sink :
a Disconnect the system fan cable from the connector on the system board [1].
b Remove the six (M2x3) screws that secure the heat sink assembly on the system board [2].
NOTE
:
• Remove the heat sink assembly screws in sequential order as indicated on the heat-sink assembly.
c Lift the heat sink assembly from the system .
Disassembly and reassembly
31