d SSD card
e SSD frame
f WLAN card
g WWAN card (optional)
h chassis frame
3 To remove the LED board:
a Lift the latch and remove the LED cable connected to the connector on the LED board [1]
b Remove the (M2.0x2.0) screw that secures the LED board to the system [2].
c Lift the LED board from the connector as shown in the gure [3].
Installing LED board
1 Place the LED board in its slot on the system.
2 Replace the M2.0x2.0 screw to secure the LED board to the system.
3 Connect the LED cable to its connector on the LED board.
4 Install the:
a chassis frame
b WWAN card (optional)
c WLAN card
d SSD frame
e SSD card
f hard drive
g battery
h base cover
5 Follow the procedure in After working inside your computer.
Disassembly and reassembly
39
To Next Page
Loading...
