Dell Latitude 5495 - Installing Power Connector Port; LED Board; Removing LED Board

Installing power connector port
1 Align the power connector port along the grooves on the slot and push it down.
2 Place the metal bracket on the power connector port.
3 Replace the M2x3 screw that secures one end of the power connector bracket to the power connector port.
4 Connect the power connector cable to the connector on the system board.
5 Ax the adhesive tape of the display cable to the power connector bracket and replace the M2x3 screw to secure another end of the
power connector bracket.
6 Install the :
a battery
b base cover
7 Follow the procedure in After working inside your computer.
LED board
Removing LED board
1 Follow the procedure in Before working inside your computer.
2 Remove the .
a base cover
b battery
c hard drive
38
Disassembly and reassembly