Installing the keyboard
1 Hold the keyboard and route the keyboard cable and the keyboard backlight cables through the palmrest in the system.
2 Align the keyboard with the screw holders on the system.
3 Replace the ve (M2x2.5) screws to secure the keyboard to the system.
4 Turn the system over and connect the keyboard cable and the keyboard backlight cable to the connectors in the system.
NOTE: When reinstalling the chassis frame ensure the keyboard cables are NOT under the lattice , but run through the
opening in the frame before connecting them to system board.
NOTE: The number of keyboard cables in the system is based on the type of the keyboard.
5 Install the:
a keyboard lattice
b battery
c base cover
6 Follow the procedure in After working inside your computer.
Power connector port
Removing the power connector port
1 Follow the procedure in Before working inside your computer.
2 Remove the :
a base cover
b battery
3 To remove the power connector port:
a Remove the M2x3 screw that secures the adhesive tape of the display cable to the power connector bracket [1], and peel o
the adhesive tape.
b Disconnect the power connector cable from the connector on the system board [2].
c Remove the M2x3 screw to release the power connector bracket that secures the power connector port to your system [3].
d Remove the power connector bracket from the system [4].
e Pull the power connector port, and lift it from the system [5].
Disassembly and reassembly
37
To Next Page
Loading...
