Installing the WWAN card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the WWAN card and provides a visual representation of the installation procedure.
Steps
1. Align the notch on the WWAN card with the tab on the WWAN slot on the system board.
2. Slide the WWAN card at an angle into the WWAN slot on the system board.
3. Connect the antenna cables to the WWAN card.
The following table provides the antenna-cable color scheme:
Table 2. Antenna-cable color scheme
Connectors on the WWAN card Antenna-cable color
Main (white triangle) White
Removing and installing components 25
To Next Page
Loading...
