Steps
1. Open the latch and disconnect the docking connector FPC from the connector on the system board.
2. Peel the docking connector from the battery.
3. Remove the two (M2x2) screws that secure the docking connector bracket to the frame.
4. Lft the docking connector bracket and slide the docking connector out of the computer.
Installing the docking connector
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the docking connector and provides a visual representation of the installation
procedure.
Removing and installing components
41
To Next Page
Loading...
