6. Connect the HALL sensor daughter board FPC and docking connector FPC to the connector on the system board and close
the latch.
Next steps
1. Install the display assembly.
2. Install the SIM tray.
3. Follow the procedure in After working inside your computer.
System board
Removing the system board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SIM tray.
3. Remove the display assembly.
4. Remove the WWAN card.
5. Remove the left system fan.
6. Remove the right system fan.
7. Remove the solid-state drive.
8. Remove the Microphone.
9. Remove the kickstand.
10. Remove the kickstand hinges.
11. Remove the heat sink.
About this task
The following images indicate the location of the system board and provide a visual representation of the removal procedure.
Removing and installing components
59
To Next Page
Loading...
