Steps
1. Remove the two (M1.6x2.5) screws that secure the Darwin cable brackets to the system board.
2. Disconnect the volume button FPC, USH FFC, audio port FPC, rear-facing camera FPC, and the power button daughter
board FPC from the system board.
3. Disconnect the Darwin antennas and the P-sensor cable from the system board.
4. Remove the two (M2x2) screws that secure the system board to the frame.
5. Lift the system board out of the system.
Installing the system board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the system board and provides a visual representation of the installation procedure.
Removing and installing components
61
To Next Page
Loading...
