Steps
1. Remove the three (M2x2) screws that secure the smart card reader support brackets to the frame.
2. Remove the smart card reader support brackets.
3. Open the latch and disconnect the smart card reader FPC from the connector on the USH board.
4. Remove the three (M2x2) screws that secure the smart card reader to the frame.
5. Lift the smart card reader off the system.
Installing the smart card reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the smart card reader and provides a visual representation of the installation
procedure.
Removing and installing components
65
To Next Page
Loading...
