Dell Latitude E4300 - System Messages

Troubleshooting: Dell Latitude E4300 Service Manual
file:///C|/Biz%20Client/2015/Lola%20(Defect%20Fix)/trouble.htm[5/25/2015 11:14:02 AM]
keyboard
failure has
occurred.
If available, connect an external keyboard.
If the problem persists, contact Dell (see Contacting Dell).
System Messages
NOTE: If the message you received is not listed in the table, see the documentation for either the operating system or
the program that was running when the message appeared.
Decreasing available memory — See Lockups and Software Problems
.
Error 8602 —
Auxiliary device failure verify that mouse and keyboard are securely attached to correct connectors.
Flash part write protected error — Contact Dell (see Contacting Dell
).
Gate A20 failure — See Lockups and Software Problems
.
Invalid configuration information - please run setup program — Enter the system setup program and change system
setup options to correct the configuration error. For more information on using the system setup program, see the Dell
Technology Guide on your computer or at support.dell.com.
Keyboard failure —
Keyboard failure or keyboard cable loose (see Keyboard
).
Memory address line failure at (address), read value expecting (value) — See Lockups and Software Problems
.
Memory double word logic failure at (address), read value expecting (value) — See Lockups and Software Problems
.
Memory odd/even logic failure at (address) read value expecting (value) — See Lockups and Software Problems
.
Memory write/read failure at (address), read value expecting (value) — See Lockups and Software Problems
.
Memory size in cmos invalid — See Lockups and Software Problems
.
No boot device available – strike F1 to retry boot, F2 for setup utility. Press F5 to run onboard diagnostics — The
system cannot detect a bootable device or partition.
If the floppy drive is your boot device, ensure that the drive is installed properly and that a bootable floppy disk
is in the drive.
If the hard drive is your boot device, ensure that the drive is installed properly and partitioned as a boot device.
Enter the system setup program and ensure that the boot sequence information is correct. For information on
using the system setup program, see the Dell Technology Guide on your computer or at support.dell.com.
No boot sector on hard-disk drive — Enter the system setup program and ensure that the configuration information for
the hard drive is correct. For information on using the system setup program, see the Dell Technology Guide on your
computer or at support.dell.com.
No timer tick interrupt — Run the Dell Diagnostics (see Dell Diagnostics
).
Non-system disk or disk error — Replace the floppy disk with one that has a bootable operating system or remove the
floppy disk and restart the computer.