8. Remove the hard-drive caddy from the hard drive.
Installing the Hard Drive
1. Attach the hard-drive caddy to the hard drive.
2. Connect the hard-drive connector.
3. Replace the hard drive in its slot.
4. Replace the hard-drive bracket to secure the hard drive.
5. Tighten the screws to secure the hard drive to the computer.
6. Install the:
a) cover
b) battery
7. Follow the procedures in
After Working Inside Your Computer
.
Removing the Memory
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove the:
a) battery
b) base cover
3. Pry the retention clips away from the memory module until it pops-up.
18
To Next Page
Loading...
