Dell PowerEdge R530 - Page 123

Figure 58. Removing a processor
1
close rst socket-release lever 2 pin-1 indicator of processor
3 processor 4 slot (4)
5 processor shield 6 open rst socket-release lever
7 socket 8 socket keys (4)
Next steps
1 Replace the processor(s).
2 Install the heat sink.
3 If removed, reinstall the PCIe expansion card riser.
4 If disconnected, reconnect the cables to the expansion card(s).
5 Reinstall the cooling shroud.
6 If required, open the expansion card latch on the cooling shroud to support the full length expansion card.
7 Follow the procedure listed in the After working inside your system section.
Related link
Safety instructions
Before working inside your system
After working inside your system
Removing the cooling shroud
Removing the optional expansion card riser
Installing the optional expansion card riser
Installing the cooling shroud
Installing a processor
Installing a heat sink
Installing and removing system components
123