Figure 67. Installing a non redundant AC PSU
1
stando on the chassis 2 screw
3 non-redundant PSU 4 PSU unit cage
5 P1 cable connector 6 P2 cable connector
7 P3 cable connector 8 backplane connector
Next steps
1 If applicable, install the PCIe expansion card riser.
2 If applicable, connect the required power or data cables to the expansion card(s).
3 Reinstall the cooling shroud.
4 If applicable open the expansion card latch on the cooling shroud to secure the full length expansion card.
5 Follow the procedure listed in the After working inside your system section.
Installing and removing system components
135
To Next Page
Loading...
