Dell PowerEdge R530 - Page 15

Item Indicator, button, or connector Icon Description
4 iDRAC8 Enterprise port
(optional)
Use the iDRAC8 Enterprise port to remotely access iDRAC. For
more information, see the Integrated Dell Remote Access Controller
User’s Guide at Dell.com/idracmanuals.
5 Full-height PCIe expansion card
slots (2)
Enables you to connect up to two full-height PCI Express expansion
cards.
6 Redundant power supply unit
AC 495 W EPP, 750 W EPP or 1100 W EPP
Or
DC 750 W
For information about supported PSUs, see the Technical
specications section.
7 Non-Redundant Power Supply
Unit
450 W
For information about supported PSUs, see the Technical
specications section.
8 Half Height PCIe expansion card
slots (5)
Allows you to connect PCIe expansion cards.
9 Ethernet connectors (2)
Integrated 10/100/1000 Mbps NIC connector
10 System identication port
Use the system identication port to connect the system status
indicator assembly through the optional cable management arm.
11 System identication button
Press the system ID button:
• To locate a particular system within a rack.
• To turn the system ID on or o.
To reset iDRAC, press and hold the button for more than 15
seconds.
NOTE: To reset iDRAC using system ID, ensure that the
system ID button is enabled in the iDRAC setup.
NOTE: If the system stops responding during POST, press
and hold the system ID button (for more than ve
seconds) to enter the BIOS progress mode.
12 USB connector Enables you to connect USB devices to the system. This port is
USB 3.0-compliant.
13 USB connector Enables you to connect USB devices to the system. This port is
USB 2.0-compliant.
14 Video/VGA port
Use the video/VGA port to connect a display to the system. For
more information about the supported video/VGA port, see the
Technical specications section.
Dell PowerEdge R530 system overview 15