Steps
1 Disconnect the display module cable from the control panel board.
NOTE: The control panel has seven tabs that secure it to the chassis.
CAUTION: Applying excessive force may damage the control panel.
2 Slide the display module cable out of the plastic cable guide.
3 Remove the cable guide after unscrewing the two retaining screws.
4 Hold the top edge of the control panel at the corners and pull upward until the control panel tabs release.
5 Pull the control panel away from the chassis.
Figure 83. Removing the control panel
1
locks on the control panel (7) 2 control panel
3 cable guide retaining screw (2) 4 cable guide
5 display module cable
Next steps
1 Reconnect the display module cable to the control panel board
2 Follow the procedure listed in the After working inside your system section.
Related link
Safety instructions
Before working inside your system
After working inside your system
152
Installing and removing system components
To Next Page
Loading...
