Installing, Removing, and Replacing
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
4 Power supply
5 Rear power switch
6 SCSI cable to host
7 Library control blade
8 Module terminators
Figure 4 Multi-Module SCSI Cabling
1 Module-to-module cable
2 Library control blade
3 GB Ethernet port
4 SCSI terminator
5 Power supply
6 Rear power switch
7 Power cords
8 SCSI cables to host
9 Module terminators
10 Ethernet cable to customer network
1 Install the library in a rack. See Installing the Library in a Rack for instructions. The instructions include procedures for
removing and replacing tape drives.
2 Connect the SCSI cables to the tape drives.
a Terminate the SCSI tape drive with an appropriate SCSI terminator.
To Next Page
Loading...
