Getting Information
file:///T|/htdocs/stor-sys/ML6000/en/html/ch06.htm[9/17/2012 1:49:55 PM]
Use the report to view detailed information on the following resources. Click on the item you want to view and the information
appears in a box to the right of the library diagram.
• Tape drives — Depending on the interface type, the information provided may not include all of the following:
interface type, tape drive type, ready state, mode (online/offline), assigned partition name, location coordinates, media
barcode ("No_Label" means unreadable barcode), media type, element address, vendor, model, physical SN, logical
SN, World Wide Node Name (WWNN), World Wide Port Name (WWPN), loop ID, topology request, speed request,
actual topology, actual speed, maximum speed, active port (if the drive has more than one FC port), SCSI ID, SAS
address, tape drive firmware level, control path status, and encryption method of each tape drive.
•
Slots
—Type, assigned partition name (storage and import/export [I/E] station slots only), location coordinates,
barcode (storage and I/E station slots only), media type, element address, encryption method, get count, get retries,
put count, and put retries. If the slot is a cleaning slot, the cleaning status (usable/expired) and cleaning count (the
number of times the cartridge was used to clean a tape drive) are also displayed. For more details about slot data, see
Viewing Slot Information.
• Partitions— Name, online status, barcode policy, number of total tape drives in the partition, number of active tape
drives partition, total media, mounted media, total slots, full slots, total I/E stations, full I/E stations, and encryption
method of each partition.
•
Modules (Chassis)
— Manufacturer, model type, and serial number of each module.
You can print the report by clicking on the printer icon in the report window.
The path to open the report from the Web client is Reports > Library Configuration.
Viewing Network Settings
To Next Page
Loading...
