Getting Information
file:///T|/htdocs/stor-sys/ML6000/en/html/ch06.htm[9/17/2012 1:49:55 PM]
Viewing System Information
The System Information report contains information on the following library settings:
• Date and time — current date, time, and time zone settings
• Physical library — host name, Internet Protocol (IP) address(es), serial number, firmware version, board support
package (BSP) level, the date the BSP was last updated, and robot firmware version.
• Encryption (this section displays only if encryption key management is licensed and configured on the library) — key
server type; encryption software version; SSL connection (enabled/disabled); primary host (primary key server IP
address or host name), primary key server port number; primary key server serial number; secondary host (secondary
key server IP address or host name); secondary key server port number; secondary key server serial number.
• Library Partitions— name, serial number, control path, status, encryption method, number of slots, number of
media, and number of tape drives.
• Tape drives — location coordinates, vendor name, model, type, physical serial number (P-SN), logical serial number
(L-SN), firmware level, sled boot version, sled application version, encryption method, and whether the tape drive is
connected to an I/O blade.
• I/O blades — if the library contains FC I/O blades, this table lists the location coordinates, World Wide Node Name
(WWNN), firmware level, and ready status.
The path to open the report from the Web client is Reports > System information.
Viewing the Library Configuration
The Library Configuration Report is a dynamic representation of the physical locations of various library resources, including
tape drives, slots, partitions, and modules.
Each partition's slots are displayed in a unique color, indicated in the legend. I/E station slots, cleaning slots, and unavailable
slots are also displayed in unique colors. A black triangle in the upper left corner of a slot indicates media is present in the
slot. A red triangle indicates media is present but the media barcode label is unreadable. A "c" in a tape drive indicates the
drive is the control path for the partition.
By default, the Library Configuration Report displays the coordinates for all licensed slots that are assigned to a partition. To
view all library slot coordinates, click Show ALL coordinates. To display the barcodes for all imported cartridges, click
Show Barcodes.
Figure 1 shows an example of the Library Configuration Report.
Figure 1 Library Configuration Report
To Next Page
Loading...
