Dell PowerVault ML6010 - Connecting Library SCSI Cables to Hosts

Installing, Removing, and Replacing
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
1 Ethernet port - do not use
2 Fibre Channel port - use this port
Figure 2 IBM LTO-5 Dual Port SAS Tape Drive
1 SAS port 1 - use this port
2 SAS port 2 - do not use
3 Ethernet port - do not use
Connecting Library SCSI Cables to Hosts
Use this procedure, along with Figure 3 and Figure 4, if you are installing a library that includes SCSI tape drives:
Warning: All libraries taller than 14U must be installed in a rack having a main protective earthing
(grounding) terminal, and power must be supplied via an industrial plug and socket-outlet and/or an
appliance coupler complying with IEC 60309 (or an equivalent national standard) and having a protective
earth (ground) conductor with a cross sectional area of at least 1.5 mm
2
(14 AWG).
To ensure proper airflow and access space, Allow 60 cm (24 inches) in the front and back of the library.
Figure 3 Stand-Alone 5U Library Control Module SCSI Cabling
1 Ethernet cable to customer network
2 GB Ethernet port