Setting Up the PowerVault ML6000 Library
file:///T|/htdocs/stor-sys/ML6000/en/html/ch01.htm[9/17/2012 1:49:11 PM]
9U Library
Expansion
Module
ML6030 CM
— One
5U Library
Control Module
and two
9U Library
Expansion
Modules
•
Installing a New Multi-Module Library Configuration
•
Installing the Library in a Rack
ML6030 CM
+ 1 ML6000
EM — One
5U Library
Control Module
and three
9U Library
Expansion
Modules
•
Installing a New Multi-Module Library Configuration
•
Installing the Library in a Rack
ML6030 CM
+ 2 ML6000
EMs — One
5U Library
Control Module
and four
9U Library
Expansion
Modules
•
Installing a New Multi-Module Library Configuration
•
Installing the Library in a Rack
Before Running and Configuring the Library
NOTE: The PowerVault ML6000 can take up to 30 minutes to perform the initial boot. It is not safe to power cycle the
library until the Setup Wizard appears in the operator panel.
NOTE: Initial power-on and initialization should occur prior to loading media. Excessive initialization time can occur
with media loaded
Initial Administrative Login ID and Password Information
• Login ID: admin
• Password: password
Setup Wizard
If you time out of the Setup Wizard or do not complete all the Setup Wizard screens, the library will apply the default
configuration settings as well as any modifications you made. See
Default Configuration Settings for more information.
Configuration Details
NOTE: You must use the Web client to manually create partitions. At the initial power-on, partitions can only be
created automatically via the operator panel user interface.
• If your PowerVault ML6000 will be configured with zero I/E station slots, be sure to complete bulk loading of tape
cartridges before configuring partitions. You may also bulk load tape cartridges while the system is powered down. For
To Next Page
Loading...
