Installing, Removing, and Replacing
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
b Turn on the front power button.
c Power up the host system.
8 Verify communication with all devices on the bus.
9 Configure the library using the commands on the operator panel. See configuration information in Configuring Your
Library.
Connecting Library FC Cables Directly to Host
Use this procedure, along with Figure 6 and Figure 7, if you are installing a library that includes FC tape drives that are
connected directly to a host.
Figure 6 Stand-Alone 5U Library Control Module Fibre Channel Cabling
1 Ethernet cable to customer network
2 GB Ethernet port
3 Power supply
4 Rear power switch
5 Power cord
6 Fibre cable to host
7 Library control blade (LCB)
8 Module terminators
Figure 7 Multi-Module Fibre Channel Cabling
To Next Page
Loading...
