Installing, Removing, and Replacing
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
1 Y-rail in unlocked, functional position
9 Repeat these steps for each module you need to re-install in the library configuration.
Preparing to Use the Library
Prepare to use the library as follows:
1 Add the tape drives to the modules. For details, see Adding, Removing, and Replacing Tape Drives.
2 Add the power supplies. For details, see Adding, Removing, and Replacing Power Supplies.
3 Add the LCB to the 5U Library Control Module. For details, see Removing and Replacing the Library Control Blade and
LCB Compact Flash Card.
4 If your library contains FC I/O blades, install both the I/O blades and the accompanying fan blades in the expansion
module. For details, see
Adding, Removing, and Replacing FC I/O Blades and Adding, Removing, and Replacing the FC
I/O Fan Blade.
5 Unpark the robot assembly.
a Gently raise the robot assembly so that it no longer rests on the parking tab.
Caution: Support the robot assembly by holding onto the broad metal X-axis plate. Lifting the robot by the thin
metal rod will bend the rod. Lifting the robot by the black plastic picker body can damage the robot.
b With your free hand, move the parking tab in a clockwise direction until it stops in the "unparked" position. When
in the correct position, the parking tab is removed completely from the interior of the module and will not
accidentally swing into the path of the robot.
c Gently release the robot assembly. It will lower to the bottom module of the library.
To Next Page
Loading...
