Installing, Removing, and Replacing
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
module's guide pin (located at the base of the front of the module) by turning it and pushing it down.
6 Tighten all thumbscrews located at the base of the front and back of the modules.
7 Fasten the module to the rack with rack ears.
8 Engage the Y-rails of the new module in your library configuration. Ensure that the Y-rails are properly aligned and
the thumbscrews are tightened.
1 Front Y-rail
2 Rear Y-rail
3 Y-rail (this end up)
4 Squeeze here to release
a From the front of the library, open the I/E station and access doors of the 9U Library Expansion Module.
b Squeeze the handle of the Y-rail release mechanism, lift it out of its locked position, and slide it downward as far
as it will go.
c From the back of the library, find the rear Y-rail release mechanism, which is located in the interior of the right
side of the module. Squeeze the handle of the Y-rail release mechanism, lift it out of its locked position, and slide
it downward as far as it will go.
Doing this aligns the Y-rails with the Y-rails of the module beneath it.
Caution: Check to make sure that there is no gap between the top and bottom Y-rails on both the front and back of
the library. If a gap exists, the library cannot mechanically initialize.
To Next Page
Loading...
