Installing, Removing, and Replacing
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
Control Module
Control Module
cover plate 5U Library
Control Module
9U Library Expansion
Module
9U Library Expansion
Module
cover plate 5U Library
Control Module
9U Library Expansion
Module
9U Library Expansion
Module
9U Library Expansion
Module
5U Library
Control Module
NEW 9U Library
Expansion Module*
NEW 9U Library
Expansion Module*
NEW 9U Library Expansion
Module*
9U Library Expansion
Module
cover plate cover plate cover plate cover plate cover plate
* Recommended location for adding a 9U Library Expansion Module.
3 Open the 9U Library Expansion Module's access door and raise the guide pin by pulling it up and turning it slightly as
if it were a screw. Otherwise, the guide pin may scratch the front doors of the module on which you are stacking it.
1 Guide pin
2 Thumbscrew
4 Lift the new 9U Library Expansion Module and, from the front of the library, place it in the desired location.
5 If there is already a module installed, secure the two modules together by tightening the two thumbscrews at the base
of the front of the module and the two thumbscrews located at the base of the back of the module. Then lower the
To Next Page
Loading...
