Installing, Removing, and Replacing
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
b If you plan to stack the 5U Library Control Module between 9U Library Expansion Modules, remove both the top
and bottom plates of the 5U Library Control Module. Also remove the top plate of the 9U Library Expansion Module
located below the 5U Library Control Module and the bottom plate of the 9U Library Expansion Module located
above the 5U Library Control Module.
c If you plan to stack the 5U Library Control Module at the bottom of the library, and if a 9U Library Expansion
Module will be located above it, remove the 5U Library Control Module's top plate and the 9U Library Expansion
Module's bottom plate.
Figure 15 Recommended Module Locations
ML6010 ML6020 ML6030
ML6030 CM + 1 9U
Expansion Module
ML6030 CM + 2 9U
Expansion Modules
cover plate
cover plate 9U Library Expansion Module
cover plate 5U Library
Control Module
5U Library
Control Module
cover plate 5U Library
Control Module
9U Library Expansion Module 9U Library Expansion Module
cover plate 5U Library
Control Module
9U Library
Expansion Module
9U Library Expansion Module 9U Library Expansion Module
5U Library
Control
Module
9U Library Expansion
Module
9U Library Expansion
Module
9U Library Expansion Module 9U Library Expansion Module
cover plate cover plate cover plate cover plate cover plate
Installing the 9U Library Expansion Module
Install the expansion module as follows:
1 Open the 9U Library Expansion Module's access door and raise the guide pin by pulling it up and turning it slightly as
if it were a screw. Otherwise, the guide pin may scratch the front doors of the module on which you are stacking.
To Next Page
Loading...
