Installing, Removing, and Replacing
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
1 Front Y-rail
2 Rear Y-rail
3 Y-rail (this end up)
4 Squeeze here to release
a From the front of the library, open the I/E station and access doors of the 9U Library Expansion Module. Squeeze
the handle of the Y-rail release mechanism, lift it out of its locked position, and slide it downward as far as it will
go.
b From the back of the library, find the rear Y-rail release mechanism, which is located in the interior of the right
side of the module. Squeeze the handle of the Y-rail release mechanism, lift it out of its locked position, and slide
it downward as far as it will go.
Caution: Check to make sure that there is no gap between the top and bottom Y-rails on both the front and back of
the library. If a gap exists, the library cannot mechanically initialize.
Doing this aligns the Y-rails with the Y-rails of the module beneath it.
Figure 16 Y-Rail in Unlocked, Functional Position
To Next Page
Loading...
