Installing, Removing, and Replacing
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
1 Guide pin
2 Thumbscrew
7 Slide the entire module toward you and lift it off of the module below it.
Replacing the 5U Library Control Module
1 If not already removed, remove the tape drives and power supplies from the 5U Library Control Module you are
replacing.
2 Using the Phillips #2 screwdriver (for the top cover plate) and the T10 TORX screwdriver (for the bottom cover plate),
remove the new 5U Library Control Module plates from the top and bottom of the module, as necessary.
Caution: Before removing the 5U Library Control Module's bottom cover plate, the robot assembly must be
parked as described in Preparing to Remove or Replace a Module.
a If your library consists of only the 5U Library Control Module, do not remove the plates.
b If you plan to stack the 5U Library Control Module at the top of the library, and if a 9U Library Expansion Module is
located below it, remove the 5U Library Control Module's bottom cover plate.
c If you plan to stack the 5U Library Control Module in the middle of the library, remove both the top and bottom
cover plates.
d If you plan to stack the 5U Library Control Module at the bottom of the library, and if a 9U Library Expansion
Module is located above it, remove the 5U Library Control Module's top cover plate.
3 Remove the LCB from the removed 5U Library Control Module and set it aside.
The LCB stores information about the library's contents and configuration, so you will probably want to install this LCB
(or possibly just the LCB compact flash card) in the new 5U Library Control Module. For details about removing the
LCB, see
Removing and Replacing the Library Control Blade and LCB Compact Flash Card.
Note: If you plan to stack the 5U Library Control Module on top of a 9U Expansion Module, be sure to park the
picker in the 5U Library Control Module first.
4 If the library configuration includes 9U Library Expansion Modules below the 5U Library Control Module, install them in
the library now.
5 Install the new 5U Library Control Module in the library. Lift the 5U Library Control Module and, from the front of the
library, place it in the desired location.
Place the 5U Library Control Module on top of the 9U Library Expansion Module and slide it to the rear of the unit. A
small notch on the bottom of the 5U Library Control Module aligns it with the top of the 9U Expansion Module.
To Next Page
Loading...
