Installing, Removing, and Replacing
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
The LCB compact flash card contains important information about your library configuration. If you replace the compact flash
card, then you need to reconfigure your library.
These instructions explain how to remove the existing LCB and existing LCB compact flash card and replace them with a new
LCB and a new LCB compact flash card. You should always replace the LCB and LCB compact flash card together.
Required tools: None
1 Power off the library.
2 Access the back of the library and locate the existing LCB.
3 Disconnect all cables from the existing LCB. You may want to label each cable that is connected to the existing LCB to
make sure that you can correctly reconnect them to the new LCB.
4 Remove the existing LCB from the library.
To remove the existing LCB, release both of the LCB latch hooks and, using the latch hooks as handles, pull the entire
LCB toward you.
5 Remove the existing LCB compact flash card from the existing LCB.
1 LCB compact flash card
6 Insert the new LCB compact flash card into the new LCB.
7 Insert the new LCB into the vacant LCB slot on the back of the library.
When inserting the new LCB into the slot, be sure that the LCB LEDs are located at the top of the blade, and that the
latch hooks are on the right side of the blade.
When sliding the new LCB into the slot, there should be no resistance.
Caution: Do not force the LCB into the slot or damage may occur.
8 After inserting the new LCB, secure it into the 5U Library Control Module by depressing both of the LCB latch hooks
into the blade. The LCB will fit snugly into its slot.
9 Reconnect all cables to the new LCB.
10 Power on the library.
The green power light on the front panel turns on. The screen may remain dark for up to 5 minutes. Then an
To Next Page
Loading...
