Installing, Removing, and Replacing
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
1 FC I/O blade
2 LEDs
3 Latch hooks, open
4 Carefully align the FC I/O blade with the guide slots in the bay. The status LEDs must be at the bottom.
Caution: Forcing the blade into the bay can cause the pins to bend.
5 Evenly apply pressure to both sides of the blade and slide it into the 9U Library Expansion Module until the latch hooks
begin to move towards the middle of the blade. Push the latch hooks towards the middle of the blade and into the
locked position. You will feel the blade pins connect with the 9U Library Expansion Module's backplane as the blade
locks into place.
Note: The LEDs for the FC I/O blade are on the bottom of the blade when the blade is correctly installed in the
expansion module.
6 Remove the necessary number of the black rubber protective covers from the ports on the FC I/O blades when you are
ready to cable the blade.
To Next Page
Loading...
