Dell PowerVault - Page 34

Recurring Syntax Syntax Value
NOTE: The physicalDiskType parameter is
not required if only one type of physical disk is
in the storage array. If you use the
physicalDiskType parameter, you must
also use the
hotSpareCount and
diskGroupWidth parameters. If you do not
use the
physicalDiskType parameter, the
configuration defaults to SAS physical disks.
NOTE: The virtualDisksPerGroupCount
parameter is the number of equal capacity
virtual disks per disk group.
create-virtual-disk-copy-attr-value-list create-virtual-disk-copy-attr-value-pair
{create-virtual-disk-copy-attr-value-pair}
create-virtual-disk-copy-attr-value-pair copyPriority=highest | high | medium | low | lowest
|
targetReadOnlyEnabled=boolean
recover-raid-virtual-disk-attr-value-list recover-raid-virtual-disk-attr-value-pair
{recover-raid-virtual-disk-attr-value-pair}
recover-raid-virtual-disk-attr-value-pair owner=(0 | 1)
Table 8. Range of Values for Recurring Syntax Elements
Recurring Syntax Syntax Values
IPV4Priority 0 to 7
IPV4VlanID 1 to 4094
IPV6Priority 0 to 7
IPV6VlanID 1 to 4094
IPV6HopLimit 0 to 255 (default value is 64)
IPV6NdDetectDuplicateAddress 0 to 256
IPV6NdReachableTime 0 to 65535 (default value is 30000 milliseconds)
IPV6RetransmitTime 0 to 65535 (default value is 1000 milliseconds)
IPV6NDTimeOut 0 to 65535 (default value is 3000 milliseconds)
maxFramePayload 1500
34