Installing system-board shield
1 Align the screw holes on the system-board shield with the screw holes on the middle frame.
CAUTION
: Make sure you do not damage the WLAN antenna when you place the system-board shield.
2 Replace the three screws (M3X4) that secure the system-board shield to the middle frame.
3 Install the:
a back cover
b USB dongle-bay cover
4 Follow the procedure in After working inside your computer
M.2 PCIe SSD
Removing M.2 PCIe SSD
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a USB dongle-bay cover
b back cover
c system-board shield
3 Open the securing clip that secures the solid-state drive to the system board [1].
4 Slide and remove the solid-state drive from the solid-state drive slot [2].
Removing and installing components
19
To Next Page
Loading...
