m memory modules
n back cover
o USB dongle-bay cover
5 Follow the procedure in After working inside your computer
Middle frame
Removing middle frame
NOTE: The following steps are applicable only for non-touch systems.
NOTE: The middle frame can be removed by removing the following components only. In this scenario, the user has to remove 15
screws that secure the middle frame to the display panel and the speaker bezel, including one screw from the media-card reader
and one screw from the power-button board.
1 USB dongle-bay cover
2 back cover
3 system-board shield
4 stand
5 inner frame
6 I/O panel
7 speakers
8 camera.
NOTE
: The middle frame can also be removed by removing all the components given in the steps below. In this scenario, the user
has to remove 13 screws that secure the middle frame to the display panel and speaker bezel
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a USB dongle-bay cover
b back cover
c memory module
d hard drive
e stand
f system-board shield
g system fan
h wireless card.
i power-supply unit.
j memory fan
k inner frame
l microphones
m I/O panel
n processor heat-sink
o processor
p hard-drive cage.
q coin-cell battery
r solid-state drive
s converter board.
t speakers
u power-button board
Removing and installing components
63
To Next Page
Loading...
