k processor.
l processor heat-sink
m I/O panel
n microphones
o inner frame
p memory fan
q power-supply unit
r wireless card
s system-board shield.
t stand
u hard drive
v memory modules
w back cover
x USB dongle-bay cover
NOTE: The middle frame can be replaced by replacing the following components only. In this scenario, the user has to
replace 13 screws securing the middle frame to the display panel.
a camera.
b speakers.
c I/O panel
d inner frame
e system-board shield.
f stand
g back cover
h USB dongle-bay cover
9 Follow the procedure in After working inside your computer
Speaker bezel
Removing speaker bezel
NOTE
: The following steps are applicable only for non-touch systems.
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a USB dongle-bay cover
b back cover
c system-board shield
d stand
e inner frame
f I/O panel
g speakers
h camera.
i middle frame
3 Lift the display panel.
4 Pull the speaker bezel away from the display panel.
66
Removing and installing components
To Next Page
Loading...
