Installing diagnostic light and button board
1 Align the screw holes on power diagnostic button and light board to the screw holes on the I/O-panel bracket.
2 Replace the screw that secures the power diagnostic button and light board to the I/O-panel bracket.
3 Align the tabs on the I/O-panel bracket with the slots on the I/O panel and snap the I/O-panel bracket in place.
4 Install the:
a I/O panel
b inner frame
c system-board shield.
d stand
e back cover
f USB dongle-bay cover
5 Follow the procedure in After working inside your computer
Drive cage
Removing HDD/SSD cage
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a USB dongle-bay cover
b back cover
c stand
d hard drive
e system-board shield.
f I/O panel
3 Remove the cable from the routing guide on drive cage [1].
4 Open the securing clips and release the HDD/SSD cables [2].
5 Disconnect the HDD/SSD cable from the system board [3].
6 Disconnect the HDD/SSD data cables from the system board [4].
44
Removing and installing components
To Next Page
Loading...
