23 SATA power connector 24 USB connector
25 CMOS clear jumper 26 side USB connector
27 touch cable connector 28 camera connector
29 display connector
Display assembly
Removing display assembly
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a USB dongle-bay cover
b back cover
c memory modules
d stand
e system fan
f inner frame
g system-board shield
h I/O panel
i processor heat-sink
j processor
k coin-cell battery
l memory fan
m wireless card
n solid-state drive
o system board
3 Press the tabs on the cable to release it from the connector [1].
4 Disconnect the cable from its slot on the middle frame [2]
5 Press the tabs on the backlight cable [3].
6 Disconnect the backlight cable from its slot on the middle frame [4].
7 Open the latch and disconnect the display cable from its slot on the middle frame.
8 Lift the display cable o the middle frame.
Removing and installing components
61
To Next Page
Loading...
