a USB dongle-bay cover
b back cover
c stand
3 Remove the power-supply unit cable from the routing guides on the system fan [1].
4 Disconnect the power-supply unit cable from its connector on the system board [2].
5 Press the securing clip to release the power-supply indicator cable from its connector [3].
6 Press the securing clip to release the power-supply fan cable from its connector [4].
7 Open the securing clips and release the cables [5].
8 Remove the ve screws (M3X4) that secure the power-supply unit to the middle cover [6].
9 Lift the power-supply unit with the cable o the middle cover [7].
Removing and installing components
31
To Next Page
Loading...
