Delta Electronics DUP-B Series

Chapter 3 Creating and Editing Screens
3.11.2 Alarm Setup
The user can set alarm by clicking Options > Alarm Setup. The alarm setup should set with
the alarm function in element settings. HMI will execute alarm function automatically if both
settings are all set. When the specified conditions are matched (If condition occurs in specific
address, ON enabled or OFF enabled) after setting, HMI will display an Alarm Setup warning
dialog box automatically. In this dialog box (Fig. 3-11-1), there are Delete, Modify, Import,
Export and OK buttons for the user to use.
Fig. 3-11-1 Alarm Setup dialog box
Alarm Setup Dialog Box
Address
Use this option to set the alarm starting address. It provides
512 alarms, 32 Words. Please note that the unit of this
address is Word. If the connecting controller is Delta PLC,
when the register type is M or S, the address must be 0 or
the multiple of 16, i.e. M0 and M16. If the address is M1,
system will determine it is an invalid address.
Alarm Setting
Scan Time
(second)（秒）
Set how long it takes for the HMI
to scan one time. The unit
is seconds.
Revision May, 2010 3-237