Chapter 3 Creating and Editing Screens
3.14.3.8 Communication
There are various kinds of commands for communication. For more details, please
refer to the following sections.
INITCOM (Initial setup COM port)
Equation
Var1 = INITCOM (Var2)
Explanation
This command uses initial setup COM port to start communication and set
communication protocol. After the user sets each COM port, this command starts
communication and stores the result in Var1.
Remark
Var1: Response value after communication
1: Completed normally
0: Failed
For the settings of Var2, please refer to the following table of Var2 Settings in
INITCOM (Communication Protocol).
3-354 Revision May, 2010
To Next Page
Loading...