EasyManuals Logo
Home>Delta Electronics>Control Panel>DUP-B Series

Delta Electronics DUP-B Series User Manual

Delta Electronics DUP-B Series
491 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #379 background imageLoading...
Page #379 background image
Chapter 3 Creating and Editing Screens
PUTCHARS (Output Characters by COM Port)
Equation
Var1 = PUTCHARS (Var2, Var3, Var4)
Explanation
This command outputs characters by COM port. Var1 is the response value after the
communication, Var2 is the starting address of transmission data, Var3 is the data
length, and Var4 is the allowance communication time (unit is ms). The result will be
stored in Var1.
Remark
Var1: Response value after communication
1: Completed normally
0: Failed
Var1 and Var2 can be internal memory only. Var3 and Var4 can be internal
memory or constant.
Example
Output three consecutive WORD data starting from $1 and store the result in $0.
3-358 Revision May, 2010

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Delta Electronics DUP-B Series and is the answer not in the manual?

Delta Electronics DUP-B Series Specifications

General IconGeneral
BrandDelta Electronics
ModelDUP-B Series
CategoryControl Panel
LanguageEnglish