Delta Electronics DUP-B Series

Chapter 3 Creating and Editing Screens
 STATIONON (Station ON)
Equation
STATIONON (Var1, Var2)
Explanation
This command is used to enable the Var2 number of station of Var1 COM port.
Var1 represents as constant 0(COM1), 1(COM2) or 2(COM3, for some models only).
Remark
 Var1 and Var2 can be internal memory or constant.
 This macro command cannot be used When Communication Interrupt times
then ignore box is checked (Options > Configuration > COM Port).
Example
Enable the first station of COM1 port.
 STATIONOFF (Station OFF)
Equation
STATIONOFF (Var1, Var2)
Explanation
This command is used to disable the Var2 number of station of Var1 COM port.
Var1 represents as constant 0(COM1), 1(COM2) or 2(COM3, for some models only).
Remark
 Var1 and Var2 can be internal memory or constant.
 This macro command cannot be used When Communication Interrupt times
then ignore box is checked (Options > Configuration > COM Port).
3-364 Revision May, 2010